Specification of how to render vector arrows for the given result on the model, on cutting planes and on isosurfaces.
Use this object to control the visual appearance of vector arrows in the 3D viewer. With colorMode you can specify whether vectors should use a singleVectorColor or the color mapping from the object's scalar result. You can also setup relative or absolute scaling with scaleMode and perform filtering and clamping of the vector magnitudes (lengths), with setFilteringRange and setClampingRange respectively.
The maximum length the vectors will have if clamping is enabled. This will be undefined if clamping is disabled.
The minimum length the vectors will have if clamping is enabled. This will be undefined if clamping is disabled.
The coloring mode of the vector arrows. This can be either single color, as specified by singleVectorColor,
or color by fringes, where the color is taken from the scalar result in the object on which the vector arrows are mapped.
If there are more vectors than specified with setDrawMaximumCount(), every n'th vector arrow will be skipped to reduce the number of arrows to within maximum count.
When set to 0, all vectors will be drawn
Note! If drawSkipBy is set to value other than 0, this skip by value will be used and maximum count ignored!
Get number of vectors to skip between each vector that is drawn. Default 0.
If set > 0, will draw every n'th vector. No guarantee of an even distribution.
The maximum length the vectors need to have to be visible when filtering is enabled. This will be undefined if filtering is disabled.
The minimum length the vectors need to have to be visible when filtering is enabled. This will be undefined if filtering is disabled.
Whether clamping of this vector result is enabled.
Whether filtering of this vector result is enabled.
The id (>=0) of the vector result. This id corresponds to the id in ModelDirectory.vectorResultArray.
The scaling factor to use for the vector arrows. This factor is interpreted as either absolute or relative based on
The scaling mode to use for the vector arrows (absolute or relative).
The color to use for the vectors if colorMode is SINGLE.
Disables any clamping of the vectors. They will be rendered with the length specified by the vector result and scaling.
Disables any filtering of the vectors. They will be rendered with the length specified by the vector result and scaling.
Specifies to clamp all vectors between the given min and max length.
When enabled, all vectors will be clamped into the given <clampMinLength, clampMaxLength> range. So if clampMinLength = clampMaxLength, all vectors will be drawn with the same length, regardless of the magnitude of the vector.
Note: The clamping is done before any scaling.
Specifies to show only the vectors whose length lies within the given range.
When enabled, only vectors whose length is within the given filter range <filterMinLength, filterMaxLength> will be drawn. All other vectors will be discarded and not drawn.
Note: The filtering is done before any scaling.
Applies the settings in the given properties object to this vector settings
Generated using TypeDoc